What makes cd skip

The most common solution in this situation is to replace the drive. World View. More From Reference. What Are the Dimensions of a Traffic Light? I had observed that CDs always started skipping between 4. That was an indicator of a "location problem". Detail: Remove the cover. Visually look for the metal guide rail shaft. It is located at the rear left of the player where the laser movement mechanisms are located when looking from the front, and is seen in between the black plastic.

Now, reach into the access to the metal guide rail with a Q-tip moderately saturated with oil 3 in 1, gun oil in my case , and wipe along the accessible surface of the metal guide rail surface; the "backside" of the rail opposite the access area cannot be be reached for lubrication without further disassembly.

But reach around "behind" the rail as far as practical. This lubrication task is very easy to accomplish and should have been included in the manual. I had previously done some disassembly and cleaned the black "split drive rack" gear , then re-lubed it with white lithium grease. This lubrication did not solve the skipping problem. These players are not sold any more, but it sure is convenient to load up as many as CDs - and avoid e-wasting an otherwise useful CD player.

LOG IN. The tracks will begin playing, and then the player will skip to another place on the track, to the beginning of the track, or to another track. I tried cleaning the laser lens and this did not work. Any ideas on what could be causing this? Thanks for your help. Edit Delete. The laser mechanisms deteriorate with age and use so it is likely this part needs to be replaced. There is also an adjustment process that is required that typically requires some test bench equipment so it is not simply the installation of a new part.

As such, it is generally not a self service item. You may find it wiser to replace the unit from eBay or even use this as the opportunity to move to a PC based music server. There may be some hope for your Sony yet Sometimes CD players will skip when the factory lubricant on the guide rails that the laser rides on dries up. When the laser sled comes in contact with the dried up lubircant patch on the guide rails If you tell the tech that the player is skipping Your Sony may still have plenty of life left in it Method 4.

Hold the disc with its shiny side up in clear view of a bright light. Flip the disc and mark the areas holes with a permanent marker.

Take 2 small strips of masking tape and stick them on top of each other over the area you have just marked. By observing the scratches with your eyes, you should be able to see how deep they are.

The reflection of the light will be a clue. Not Helpful 11 Helpful Not Helpful 17 Helpful Not Helpful 12 Helpful Sliced fresh banana can clean up minor smudges and scratches on a CD. Rub a banana slice over the CD and wipe it off with the inside of the banana peel. Then use a clean cotton cloth to wipe down the CD. Not Helpful 57 Helpful If the scratches are bad, yes. It's more about how deep the scratches are than how many there are. Not Helpful 9 Helpful Not Helpful 10 Helpful However, if you take it to a professional, they may be able to copy the information onto another disk.

Not Helpful 7 Helpful Not only is my disc not playing properly, but it has static all though the recording now that wasn't there before. So far, none of these have helped. Any idea what this could be? That happened to mine as well, I figured out that it was because my toothpaste had a sort of fine grit in it that scratched up the entire surface, ruining my brand new CD.

What I would suggest would be to try the wax solution and burn a new one. I used the toothpaste method for my Just Dance 2 game with heavily used toothpaste and it worked perfectly. Not Helpful 19 Helpful Not Helpful 26 Helpful Include your email address to get a message when this question is answered. By using this service, some information may be shared with YouTube.

Try using a dry "Mr. Clean Magic Eraser" to remove scratches. Use light pressure, wiping from the center of the disk to the outside edge just as described with other polishing methods. The repaired area can be buffed until shiny using the other polishing or waxing techniques described.

Helpful 5 Not Helpful 0. Practice repairing scratched CD's that you do not care much about before you set out to repair your favorites. Helpful 3 Not Helpful 0. You can use an iPad or iPhone cleaning cloth, instead of a eyeglass cleaner. Helpful 1 Not Helpful 2. It is a good idea to create a backup of any data disc before damage occurs. Instead of toothpaste, consider using peanut butter.

The oily viscosity of peanut butter makes for an effective polishing compound. Make sure it's the smooth kind! Helpful 0 Not Helpful 1. Severely damaged CDs may not be salvageable. Very deep scratches and cracks that reach the CD's foil will make the CD useless. Helpful 0 Not Helpful 2. If the CD is irreparable, use it as a coaster for your beverages!

Buy a cleaning disc from any electronics or department store and use it in your machine. These discs have small brushes that clean the laser emitter. Clean the mechanical arm. The laser is housed on an arm that moves while the CD is playing.

Dust or debris can easily cause the arm to get stuck. Spraying compressed air into the CD slot can remove this dirt and allow the arm to move freely again. Open the CD case.